Start with the instructions for the exact fitting. Some shower arm connections use sealant on the threads. A hand-shower hose with a flat washer seals where the washer is pressed against the mating face. The hose threads bring those faces together. Tape on those threads cannot replace a missing washer.
Compare the joints before buying parts
| Joint in the example | What forms the seal | What to check |
|---|---|---|
| Kohler 1/2-inch NPT supply nipple | Threaded pipe joint with thread sealant tape as specified | Check the actual thread designation and the fitting instructions. The nominal size alone does not identify the thread. |
| Delta showerhead connection to the existing arm | Delta calls for a washer check and limits plumber tape to this connection in sheet 87847 | Use the instructions for the actual showerhead. Other designs can use a gasket at the arm. |
| Hose ends on the same Delta shower system | A washer seated inside each applicable hose nut | Look for a missing, displaced or damaged washer and a mating face the washer can sit against. |
Find the first wet joint
Turn off the shower, dry the exposed connections, and briefly run water while watching where the first drop forms. Water can travel down a hose or over the outside of a nut, so a drop at the lowest point can come from a joint above it. Turn the water off again before loosening a fitting.
If the first drop comes from a washer-style hose nut, inspect the washer and the mating face. Start the nut squarely by hand and follow the specified tightening instructions. If threads bind early, stop and confirm the two ends are intended to mate. If water appears at or behind the wall trim, stop using the shower until the concealed connection can be checked.
Match the connection and the seal
For a replacement hose or adapter, record the model number, the specified thread on each end, and the gasket or seal shown in the parts diagram. A nominal 1/2-inch label or a nut that begins to turn does not establish compatibility. Check the connection on the diverter or bracket separately from the connection on the hand shower. Keep any model-specific flow or backflow components in place according to the installation sheet.
The examples compare documented sealing arrangements and do not establish cross-brand compatibility. For water-use comparisons, see the showerhead catalog and the guide to multiple shower outlets.